Mortar mortar pump sprayer * * Wall sprayer operation Guide 1, before starting the class, press hands-oiling pump several times to transmission parts. 2, after the power is turned on, the first electric main motor, check the rubber screw rotation direction is consistent, if not, that is, to exchange power phase (this check should be carried out every re-connect the supply) 3, take a good delivery hose and nozzle, add water to the hopper 5L, start the motor out of the water pump to wet the hopper, pump and delivery hose, pump out most of the water will be shut down after. 4, adding to the hopper can be switched putty or paint spraying (air compressor should be started and open valve) 5, is strictly prohibited without material hopper, anhydrous state idling. 6, the work is completed to be drained of excess material in the hopper, the hopper to inject enough water, clean the hopper and turn the pump out, cleaning hose and nozzle until the pump out all the water, in order to avoid more than expected in hose types solidified, clogging the hose and nozzle. 7, downtime is too long, wipe clean the machine and remove the screw supercharger, after oiling, safekeeping, reinstall use. 8, there pump out less pressure, adjust or replace the booster booster stator bolt sleeve and supercharged worm work. 9, before spraying, spraying area should be subject to infiltration of water; and when the spray nozzle as vertical surface by spraying (spraying distance can be adjusted according to its own effect) stratified uniform spray, and coordinated processes and income level. After spraying the wall is too dry or too long will seriously affect the income level effect, to change the process. 10, into the hopper charging should be uniform, without interruption, when the rotating screw conveyor, is strictly prohibited in the hopper agitation with sticks, to prevent injury. 11, spray duct blockage once the switch to manual position, and only the compressor, the quick connector Remove the front head, but after a solid block upside down spray, air pressure generated back pressure, the ducts than pulp blowing in the quick connector installed, start working properly. 12, jet-hand operation, should wear safety helmets, safety glasses, protective clothing and other protective equipment. 13, pressure sleeve and screw supercharger for wearing parts for long life, during the initial use, even in a loose bolt stator pressurized state until the pressure is reduced, the adjustment bolts when flow was significantly reduced, making it in normal working conditions. Manufacturers Phone: 1 3 9 3 8 2 2 7 7 6 9 QQ: 1 0 4 4 5 1 9 1 9 6 WD-3000-type mortar spraying machine technical parameters: Production capacity: 3m3 / H Maximum pressure: 3MPA Motor power: 7.5 KW transmission distance: 50 m Voltage: 380V maximum bone particle size: <4mm air consumption: 0.36m3 / min machine weight: 300KG